Are you over 18 and want to see adult content?
More Annotations
Streetwear & Hip Hop Klamotten Online Shop | DefShop
Are you over 18 and want to see adult content?
MelBet - Scommesse, Live, Bonus 100€ | MelBet Bookmaker
Are you over 18 and want to see adult content?
Small Boat Restoration
Are you over 18 and want to see adult content?
Receitas na Rede - As receitas dos melhores blogs em Português.
Are you over 18 and want to see adult content?
Organic Raw Chocolate - Ombar - Naturally Better
Are you over 18 and want to see adult content?
Nowamuzyka.pl - Elektronika, Nowe Brzmienia, Eksperyment
Are you over 18 and want to see adult content?
SYSTEM||BAHN - Fachportal für den Schienenverkehr
Are you over 18 and want to see adult content?
Favourite Annotations
A complete backup of shawneemission.org
Are you over 18 and want to see adult content?
A complete backup of southerninlaw.com
Are you over 18 and want to see adult content?
A complete backup of antivirustricks.com
Are you over 18 and want to see adult content?
A complete backup of thethaominhphu.com
Are you over 18 and want to see adult content?
Text
CISCO NETWORKING
Skip to content
* Home
* About
← Older posts
AWS NETWORKING. PART 2. BRIDGING AND ROUTING Posted on 13.08.2019by yurmag
Most of the information in this post was taken form AWS documentationpages .
AWS network differs from conventional on-perm networks. For example, it does not support broadcast or multicast frames. Continue reading → Posted in Без рубрики | Tagged aws | Leave acomment
AWS NETWORKING. PART 1. INTRODUCTION Posted on 06.08.2019by yurmag
AWS Networking. Part 1. Introduction Most of the information in this post was taken form AWS documentationpages .
A VIRTUAL PRIVATE CLOUD (VPC) is a virtual network dedicated to your AWS account. It is LOGICALLY ISOLATED from other virtual networks in the AWS Cloud. You can launch your AWS resources, such as Amazon EC2 instances, into your VPC. You can specify an IP address range for the VPC, add subnets, associate security groups, and configure routetables.
Continue reading → Posted in Без рубрики | Tagged aws | Leave acomment
CREATING CISCO CSR1000V AMI IN AWS Posted on 24.07.2019by yurmag
At the time of this writing, AWS provides Cisco SCR1000v BYOL with IOS version 16.09. You can update it using conventional method with new *.bin file, but it does not scale. What you probably want is to create and AMI with desired version and use it in your deployments. Here is the procedure for that. Continue reading → Posted in Без рубрики | Tagged aws | Leave acomment
CISCO CSR1000V SMART LICENSE IN VRF Posted on 17.06.2019by yurmag
Smart license implies “on-line” use of licenses from you Cisco Smart Software Manager (CSSM) server . There are tree methods of acquiring licenses for Cisco devices: 1) from Cisco public CSSM (over Internet connection) 2) from CSSM On-prem / CSSM satellite (over private networkinfrastructure)
3) license reservation feature (Offline) First method is the easiest one. Second is more “secure”. The last method may not available by default. Continue reading → Posted in Без рубрики | Tagged aws , smartlicense | Leave
a comment
MPLS. PART 2. LDP
Posted on 02.03.2019by
yurmag
Label Distribution Protocol is used for building LSPs that follows IGP best paths. LDP maps labels to non-BGP prefixes in GRT / Default RIB; these lables are TRANSPORT lables. LDP is one of four MPLS builders :LDP, RSVP-TE, BGP, and the Interior Gateway Protocol(IGP) .
Continue reading → Posted in Без рубрики| Tagged ldp , mpls
| Leave a comment
MPLS. PART 1. BASICS Posted on 22.01.2019by
yurmag
Multiprotocol Label Switching (MPLS), is probably a superior of Asynchronous Transfer Mode (ATM) technology. By probably, I mean that there may not be a strict link between those two, but there are manysimilarities.
MPLS is an asynchronous packet-based forwarding technology that uses LIGHTWEIGHT FORWARDING PLANE, which allows devices in the transit path not to perform a lookup based on the original packet destination field, but only to forward packet based on a label. Continue reading → Posted in Без рубрики | Tagged mpls | Leave acomment
PORT-RANGE NAT OR HOW TO MAKE YOUR EVE-NG HOST AVAILABLE FROM OUTSIDE Posted on 20.01.2019by yurmag
!!! CONSOLE ACCESS PART ! THE ADDRESS OF YOUR EVE-NG HOST ip nat pool _nat-pool_ 192.168.136.6 192.168.136.6 prefix-length 30 type rotary ! RANGE OF NEEDED UDP PORTS. THE FOLLOWING RANGE OF PORTS IS ENOUGH FOR ONE ACTIVE LAB ip access-list extended _acl-nat-range_ permit tcp any any range 32769 32897 ! BIND THOSE TWO TOGETHER ip nat inside destination list _acl-nat-range_ pool _nat-pool_ !!! WEB INTERFACE PART ip nat inside source static tcp 192.168.136.6 80 interface FastEthernet4 80 Posted in Без рубрики| Tagged nat ios |
Leave a comment
← Older posts
*
TAGS
* aaa
* arp
* asa
* aws
* bfd
* bgp
* bridging
* cacti
* centos
* classful routing
* csma/cd
* dhcp
* dmvpn
* dns
* dtp
* eem
* eigrp
* ethernet
* ezvpn
* fex
* frame-relay
* ftp
* fun
* git
* glbp
* gre
* habr
* hsrp
* ikev1
* ikev2
* initial config
* ios
* ios-xr
* ip
* ipsec
* ipv4
* ipv6
* is-is
* l2 security
* lacp
* ldp
* local proxy arp
* mGRE
* mpls
* mstp
* mtu
* multicast
* nat asa
* nat ios
* ndp
* nexus
* nhrp
* ospfv2
* pim
* pki
* port channel
* powershell
* ppp
* Private vlan
* qos
* rip
* routing
* rstp
* san
* smart license
* split horizon
* stp
* syslog
* tcp
* urpf
* vpc
* VRF-aware management* vrrp
* vtp
* vxlan
* wifi
* ZBWF
Cisco networking
Create a free website or blog at WordPress.com.Cisco networking
Create a free website or blog at WordPress.com.Post to
Cancel
Privacy & Cookies: This site uses cookies. By continuing to use this website, you agree to their use. To find out more, including how to control cookies, see here: CookiePolicy
* Follow
*
* Cisco networking
* Customize
* Follow
* Sign up
* Log in
* Report this content * Manage subscriptions* Collapse this bar
Details
Copyright © 2024 ArchiveBay.com. All rights reserved. Terms of Use | Privacy Policy | DMCA | 2021 | Feedback | Advertising | RSS 2.0